Serial: TBC
Surface
New
Cantaluppi
£ P.O.A
Download PDF
Enter your email address to continue:
Cantaluppi Model RV.2000 Surface Grinding Machine
Photos
Description
Features
Alternatives
Video
Accessories
| Machine Specification | |
| Machine bed of cast iron, provided with ways of | 3500mm length |
| Table made of cast material, provided with guideways | 1850mm length |
| Table surface | 1700 x 380mm |
| Longitudinal travel of table | 2050mm |
| Max. length parallel pattern | 1700mm |
| Max. length crossed pattern | 1500mm |
| Column made of cast iron provided with two flat front side guideways for travel of wheel support | |
| Length of guideways | 1400mm |
| Wheel motor support of cast iron provided with flat guideways adjustable having a length of | 750mm |
| Maximum grinding height from table surface to new grinding wheel | 500mm |
| Wheel motor of closed type | 20 kw |
| with forced ventilation and automatic take up of play rotational speed | 1000rpm |
| External diameter of segment holders | 400mm |
| Size of segments (10-off) | 25 x 80 x 150mm |
| Overall working dimensions | 5700 x 2000 x 2800mm |
| Approximate total weight of machine | 8500 kg |
| Machine supplied complete with |
| Electric equipment to C.E standards complete with motor protectors; control circuits voltage 110V, 1ph, 50-Hz, power drive voltage 400v, 3ph,50Hz |
| Hydraulic power system complete with 5.5kw motor for driving the two fixed volume pump, one for longitudinal and the other for auxiliary control. The whole equipment is fitted on a 200 litre separate power unit, complete with heat exchanger. The unit will be supplied without oil. |
| Coolant system complete with 0.18 hp motor pump unit, fitted on an externally located filter tank |
| Vertical axis travel by ballscrews driven by DC motor with transmission ratio through toothed belts |
| Device for wheelhead downfeed synchronised with reverse of table motion (all) to be selected according to the different position reverse; rate of downfeed programmable on the positioner and stopping at the pre-determined size |
| Device for continuous adjustment of table travel speed from 0.5 - 25 m/min by means of proportional valve. The table is driven by a double acting cylinder |
| Safeguards for protecting the guideways, the table and the grinding wheel. Full enclosure for the entire grinding area complete with safety devices interlinked with machine operation. |
| Set of service spanners |
| Manual for use and maintenance of machine |
| Manual straight dressing device without diamond |
| Counterweight of wheel head |
| Segment holders complete with 10-off segments, 25 x 80 x 150mm |
| Mono axis positioner for manual travel in stepwise or continuous mode of the vertical axis, with display of the respective dimensions. Possibility of pre-setting of dimensions. Setting of semi-automatic or automatic grinding cycle with the following steps:- |
| Rapid approaching to the workpiece at the preset size |
| Roughing start with the preset downfeed rates |
| Finishing start with the preset downfeed rates |
| Downfeed stop at the pre-determined size |
| Spark out start for programmed number of strokes |
| Machine axes stop in workpiece unloading position |
| Wheelhead upwards to the pre-determined height |
| All motors stop and cycle end |
To the best of our knowledge the content of this Website are correct, however illustrations, specifications and prices are not binding in detail.